HoodEx

Weak extraction after a renovation or new equipment?

The exhaust worked fine until the refit. Now the hood barely pulls, the line is smoky and nobody can say what went wrong. Usually several small changes add up: a new piece of equipment, a longer duct, a closed-up ceiling or a fan that was never touched. An exhaust is planned for a particular kitchen, and when the kitchen changes, the exhaust has to change with it.

Why it happens

New equipment that cooks heavier

A charcoal grill, extra fryers or a wok range in place of a flat griddle can need far more extraction than the system was built for.

A longer or bendier duct

To fit a new layout, the duct may have been extended or given extra bends. Every metre and every bend makes the fan work harder for the same airflow.

A second hood on the same fan

Adding a hood to an existing duct shares the fan between two hoods. Neither gets what it needs.

The fresh air was cut off

New partitions, doors or ceilings can block the openings that used to let replacement air in. The exhaust then cannot pull its full amount.

Things left behind by the works

A damper left closed, debris in the duct, the wrong filters fitted or a fan rewired to run backwards can all choke the system. Fan wiring is for an electrician to check.

Quick checks your team can do safely

  1. List what changed in the works: equipment, layout, ceiling, doors, duct route. Old and new drawings help.
  2. Check the filters fitted are the right type and size, clean and with no gaps.
  3. See whether the doors became hard to open after the works, which points to fresh air.
  4. Feel for airflow at each filter with a strip of tissue. A dead section suggests a blockage or a closed damper.
  5. Ask the fit-out contractor whether the fan or its wiring was touched.

These checks are from the floor, with nothing opened. Do not open the exhaust fan or any electrical panel, and do not go onto the roof or into the ceiling. Leave those to a trained crew or an electrician.

How HoodEx fixes it

We visit, ask what changed and check the system end to end: hood, filters, duct route, fan and the fresh air. We also clean if the works left grease or dust in the system.

Most cases are solved by modifying the exhaust: extending the hood over new equipment, re-routing a duct to remove bends, separating hoods onto their own fans, or upgrading the fan. See also kitchen hood installation, exhaust duct installation and exhaust fan installation.

Where the works removed the fresh air, a fresh air system brings it back.

If you are planning a refit now, involve us before the ceiling is closed. It is much cheaper to plan the exhaust with the new layout than to fix it afterwards.

When to call us

Call us as soon as the new kitchen struggles in service, or before the works start if you can. We work night shifts so a trading kitchen does not have to close.

Every job starts with a site visit. We see the kitchen, find the cause and explain what it needs before we quote. HoodEx works in all seven emirates and Al Ain, in restaurants, hotels, cloud kitchens, villas and apartments.

Frequently asked questions

Why is my kitchen exhaust weak after the renovation?

Usually the works changed what the exhaust has to do: heavier equipment, a longer duct, an extra hood on the same fan, or less fresh air coming in. Sometimes a damper or debris is simply blocking the duct.

Can the existing exhaust be adapted to new equipment?

Often, yes. Hoods can be extended, ducts re-routed and fans upgraded. We check at a site visit whether modifying makes more sense than replacing.

We added a second hood to the same duct. Is that a problem?

It can be. Two hoods on one fan share the airflow, and the one furthest from the fan often gets very little. The duct and fan need checking for the combined load.

When should we involve you in a refit?

Before the layout is fixed and the ceiling is closed. Then the hood, duct and fan can be planned with the new kitchen.

Book a site visit.

Tell us what is happening in your kitchen. We visit by day or on a night shift and recommend only what is needed.

+971 56 391 1944WhatsAppGet Quote