HoodEx
← Blog

Kitchen Exhaust Duct Routing: The Basics Every Restaurant Owner Should Know

10 November 2026 · 4 min read

The duct is the part of the exhaust you see least and live with longest. Hoods get replaced and fans get swapped, but a duct buried above a ceiling or inside a shaft usually stays for the life of the kitchen. A good route makes the whole system quieter, cheaper to run and easier to clean. A bad one causes trouble that no amount of fan power fixes.

Shorter and straighter is better

Every length of duct and every bend resists the air moving through it. Two gentle bends are kinder to the fan than one sharp elbow, and a straight climb to the roof beats a long wander across the ceiling. When a route has to be long, the fan has to be chosen for it, and the duct needs more access points for cleaning.

Let grease drain

Grease condenses on the inside of the duct as the air cools. It has to have somewhere to go. Horizontal runs should fall back toward the hood or to a point where grease can be collected, never sag in the middle. A low spot in a duct fills with grease over time, and that pool is where duct fires often start.

Sealed joints, not screwed seams

Kitchen exhaust duct carries hot, greasy air, so its joints have to be sealed so grease cannot seep out onto ceilings and insulation. That is why grease duct is usually made of heavier steel with welded or specially sealed joints, not the light ducting used for air conditioning.

Keep clear of anything that burns

A grease duct needs clearance from timber, insulation, cables and other things that can catch fire. Where it passes through floors or fire-rated walls in a multi-storey building, it normally runs inside a fire-rated shaft or wrap. The building will usually tell you how it expects that to be done.

Plan the access panels with the route

A duct that cannot be reached cannot be cleaned. Access panels belong at changes of direction and along long straight runs, placed where a crew can reach them without dismantling the ceiling. Our guide to duct access panels goes into where they go and why.

  • Keep the route as short and direct as the building allows
  • Use gentle bends and as few of them as possible
  • Fall back toward the hood on horizontal runs; no sags
  • Sealed joints and heavier duct made for grease
  • Clearance from anything combustible, and fire-rated protection through floors
  • Access panels at bends and along long runs
  • A discharge point away from windows, intakes and people

NFPA 96 is the standard most kitchens follow for grease duct work, and your landlord, building or local authority may add their own rules. HoodEx carries out exhaust duct installation, extension and re-routing in the UAE, planned with the kitchen hood installation and the fan. For an existing duct, see kitchen duct cleaning.

Frequently asked questions

Why should a kitchen duct slope?

So grease that condenses inside drains back toward the hood or a collection point instead of pooling in a low spot.

Can kitchen exhaust use normal air conditioning ducting?

No. Grease duct needs heavier metal and sealed joints so hot grease cannot leak out.

Can an existing duct be re-routed?

Often, yes, if it is in good condition. Re-routing can remove sags and sharp bends and add access panels at the same time.

Need your exhaust system cleaned?

HoodEx cleans the full system — hood, filters, duct, fan and ESP unit — across the UAE. See our services or the areas we serve.

Book a Cleaning
+971 56 391 1944WhatsAppGet Quote