Two companies can both say they cleaned your duct and mean very different things. The method decides how much of the run was actually reached. Here is what the common methods do, and the questions that tell you which one you are getting.
| Method | Works well for | Limits |
|---|---|---|
| Hand scraping | Thick deposits close to an access point, hood collars, plenums | Only as far as an arm and tool can reach |
| Rotary brush machine | Long runs and sections that cannot be reached by hand | Needs an entry point; bends and very heavy deposits may need scraping first |
| Chemical degreasing | Softening baked-on grease so it can be removed | Does nothing alone; needs rinsing and a way to collect the run-off |
| Hot water or steam | Rinsing and lifting softened grease where drainage is possible | Water must be contained, or it leaks through joints and ceilings |
Most proper duct cleans combine more than one of these.
Why hand cleaning alone falls short
Hand scraping is good at the first metre or so past an opening. Beyond that, nobody can see or reach the surface. If a duct has a few openings and only hand tools are used, the sections between them stay dirty, and the visible parts near the panels look fine in the photos.
How a rotary brush machine works
A control unit turns a brush on a flexible cable that is fed along the inside of the duct. The rotating brush scrubs grease from the inner surface as it travels. This is the method HoodEx uses for sections hand cleaning cannot reach, and it is why duct cleaning needs specialist equipment rather than a ladder and a scraper.
Where the grease goes
Loosened grease has to be collected and taken out of the duct, not just moved further along it. Ask how the crew collects it, and how the kitchen below is protected from drips. Grease left lying at the bottom of a riser is still fuel.
Questions to ask any duct cleaner
- What equipment will you use for the sections you cannot reach by hand?
- Will the whole run be cleaned, or only near the access points?
- Which sections could not be reached, and will that be in writing?
- Will I get photos from inside the duct, before and after?
- How will the kitchen and ceilings be protected?
For the bigger picture, read how to choose a hood cleaning company. To see how we work, visit our exhaust duct cleaning page or contact HoodEx for an inspection.
Frequently asked questions
Which duct cleaning method should I choose?
It depends on the duct. Most jobs combine degreasing, scraping near openings and machine brushing along the run. A single method rarely reaches everything.
Does chemical cleaning alone clean a duct?
No. Chemicals soften grease, but it still has to be physically removed and collected.
Is kitchen duct cleaning the same as AC duct cleaning?
No. A kitchen exhaust duct carries grease and fumes out of the building and needs degreasing. An AC duct carries conditioned air and is a different system.
Related reading
A plain guide to kitchen exhaust duct cleaning in Dubai: why grease builds up inside the duct, how often to clean it, what a proper job covers and what to ask before you book.
Kitchen extract cleaning, extraction cleaning, exhaust cleaning: what the different names mean, which parts of the system are included and how to compare quotes in the UAE.
How kitchen exhaust cleaning works for mall and food court outlets in Dubai: shared ducts, ecology units, night shifts, mall permits and what outlet managers should prepare.
Related services
Need your exhaust system cleaned?
HoodEx cleans the full system — hood, filters, duct, fan and ESP unit — across the UAE. See our services or the areas we serve.
Book a Cleaning